AEG BP1731410 User Manual page 38

38 www.aeg.com
Problem
The oven does not heat up.
The lamp does not operate.
The display does not show
the time during the off sta-
tus.
The core temperature sensor
does not operate.
It takes too long to cook the
dishes or they cook too
quickly.
Steam and condensation
settle on the food and in the
cavity of the oven.
The display shows "C2".
The display shows "C3".
The display shows "F102".
Possible cause
The fuse is released.
The lamp is defective.
The display is deactivated.
The plug of the core tem-
perature sensor is not cor-
rectly installed into the sock-
et.
The temperature is too low
or too high.
You left the dish in the oven
for too long.
You want to start the Pyroly-
sis or the Defrost function,
but you did not remove the
core temperature sensor
plug from the socket.
The cleaning function does
not operate. You did not
fully close the door, or the
door lock is defective.
• You did not fully close
the door.
• The door lock is defec-
tive.
Remedy
Make sure that the fuse is
the cause of the malfunction.
If the fuse releases again
and again, contact a quali-
fied electrician.
Replace the lamp.
Touch and at the
same time to activate the
display again.
Put the plug of the core tem-
perature sensor as far as
possible into the socket.
Adjust the temperature if
necessary. Follow the advice
in the user manual.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Remove the core tempera-
ture sensor plug from the
socket.
Fully close the door.
• Fully close the door.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows
"F102" again, contact the
Customer Care Depart-
ment.