Delete All Scenes; Programming Chases - Beamz 154.060 Instruction Manual

1.7 DELETE ALL SCENES

1.8 BANK COPY
1. Program enable.
16
2. Tap the Bank Up/Down button to select the bank you wish to copy.
3. Tap the ADD button.
4. Tap the Bank Up/Down button to select the bank you wish to copy to.
Pro

2.0 PROGRAMMING CHASES

You must program scenes before you can program chases, this function allows you to store up to 240 scenes into one chase.
This function will reset all DMX channel to 0 output.
1. With the power off, press and hold down the Program and Bank Down buttons
at a time.
2. Apply power again, all scenes should be cleared.
5. Tap the Music/Bank Copy button, all LEDs and the Segment Display will flash three times
briefly indicating the function has been completed.
6. Press the Program button for three seconds to exit Programming mode.
1. Program enable.
2. Tap the Chase button to select the chase to program. Each time you can select a chase
only.
3. Select a desired scene from the bank that has stored scenes. (described in Programming
Scenes)
4. Tap the ADD button.
5. Repeat steps 3-4 until you've reached your desired effect.
You may record up to 240 scenes into a chase.
9