Delete A Step; Delete A Chase; Delete All Chases; Auto Mode - Beamz 154.060 Instruction Manual

2.3 DELETE A STEP

2.4 DELETE A CHASE

2.5 DELETE ALL CHASES

3.0 RUNNING SCENES
3.1 MANUAL MODE

3.2 AUTO MODE

1. Program enable.
2. Select the chase that contains the step you wish to delete.
3. Tap the Tap Sync/Display button causing the Segment Display shows the steps.
4. Tap the Bank Up/Down button to scroll to the step you wish to delete.
5. Tap the Auto/Del button to delete the step, all LEDs and the Segment Display will flash
three times briefly indicating that the step has been deleted.
1. Select the chase you wish to delete.
2. Press and hold down the Auto/Del button. Tap the Chase button while holding down the
Auto/Del button, all LEDs and the Segment Display will flash three times briefly indicating
this chase has been deleted.
1. With the power off, press and hold down the Auto/Del and Bank Down buttons at the
same time.
2. Apply the power again.
1. When the power is turned on, this unit enters Manual mode automatically.
2. Make sure Auto trigger and Music trigger indicators in the Segment Display are both off.
3. Use the Bank Up/Down button to select the bank that contains the scenes you wish to
run.
4. Tap the Scene button to select the scene to run.
This function allows you to run a bank of programmed scenes in a sequential loop.
1. Tap the Auto/Del button to activate Auto mode. The auto LED lights indicating auto mode
is active.
11