Table of Contents
Advertisement
OVERVIEW
1. Fixture buttons (1 – 12)
Used to select relevant fixture for control.
2. Scene buttons (1-8)
Press the scene buttons to load or stored your scenes.
There are a maximum of 240 programmable scenes.
3. Segment Display
Shows the current activity or programming state.
4. Bank Buttons (Up/Down)
Press the Up/Down buttons to select a bank from 30 banks.
5. Chase Buttons(1-6)
Used to select your programmed chase consisting a
maximum of 240 scenes.
6. Program Button
Used to activate Program mode.
7. ADD Button
Used to record programs.
8. Auto/Del Button
Used to activate Auto mode or to delete scenes and
chases.
REAR VIEW
1. Power Switch
This switch turns On/Off the power.
2. DMX Polarity select
Make sure the polarity of your fixture.
9. Music/Bank Copy
Used to activate Music mode or to create scenes and
chase programs.
10. Blackout Button
Used to disable channel output.
11. Tap Sync/Display
Used to create a standard beat or to change the values
display between % and 255.
12. Fade Time Slider
Used to adjust the Fade Time. Fade Time is the amount of
time it takes for a fixture(scanner) to move from one
position to another, for the dimmer to fade in or fade out.
13. Speed Slider
Used to adjust the speed at which the scenes will chase.
14. Page Select Button
Used to select faders for the fixture between Page A(1-8)
and Page B (9-16).
3. DMX Out.
This connector sends your DMX value to the DMX scanner
or DMX pack.
4. DC Input
DC 9 – 12V, 300mA
5
Advertisement
Table of Contents
