Check The Burners - Amana AM30LP-P Assembly, Installation Instructions And Use & Care Manual

4. Place the 20 lb LP gas fuel tank secure ring over the collar of
the tank as shown.
A
A. 20 lb LP gas fuel tank secure ring
B. Gas pressure regulator/hose assembly
NOTE: The 20 lb LP gas fuel tank orientation shown in the
illustration above must be followed to provide proper vapor
withdrawal.
5. Turn on the gas supply. Wait a few minutes for gas to move
through the gas line.
6. Test all connections by brushing on an approved
noncorrosive leak-detection solution. Bubbles will show a
leak. Correct any leak found.
The burners are tested and factory-set for most efficient
operation. However, variations in gas supply and other conditions
may make minor adjustments to air shutter or low flame setting
necessary.
It is recommended that a qualified person make burner
B
adjustments.
Checking the grill burner flames requires removing the grate and
flavor grids.
Burner Flame Characteristics
The flames of the grill burners and side burners (on some models)
should be blue and stable with no excessive noise or lifting (LP
gas flames will have a slightly yellow tip). A yellow flame indicates
not enough air. If flame is noisy or lifts away from the burner, there
is too much air. Some yellow tips on flames when the burner is
set to HI setting are acceptable as long as no carbon or soot
deposits appear.
Check that burners are not blocked by dirt, debris, insect nests,
etc., and clean as necessary.

Check the Burners

13