Table of Contents
Advertisement
Problem
I fully charged the
batteries, but
–
still flashes or
– the operating time
seems to be shorter.
Making/answering calls, intercom
Problem
is displayed.
Noise is heard, sound cuts
in and out.
The handset does not ring. R The ringer volume is turned off. Adjust ringer volume (page 13,
I cannot make a call.
Caller ID
Problem
Caller information is not
displayed.
Caller information is slow
to display.
0906_TGC41xCX (en)_ver002.pdf 31
Cause/solution
R Clean the battery ends (
a dry cloth and charge again.
R It is time to replace the batteries (page 8).
Cause/solution
R The handset is too far from the base unit. Move closer.
R The base unit's AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
R The handset is not registered to the base unit. Register it
(page 32).
R Activating eco mode reduces the range of the base unit in
standby mode. If required, turn eco mode off (page 12).
R You are using the handset or base unit in an area with high
electrical interference. Re-position the base unit and use the
handset away from sources of interference.
R Move closer to the base unit.
R If you use a DSL/ADSL service, we recommend connecting a
DSL/ADSL filter between the base unit and the telephone line
jack. Contact your DSL/ADSL provider for details.
19).
R The dialling mode may be set incorrectly. Change the setting
(page 12).
R You dialled a call restricted number (page 23).
R The key lock feature is turned on. Turn it off (page 15).
Cause/solution
R You must subscribe to a Caller ID service. Contact your phone
service provider for details.
R If your unit is connected to any additional telephone
equipment, remove and plug the unit directly into the wall jack.
R If you use a DSL/ADSL service, we recommend connecting a
DSL/ADSL filter between the base unit and the telephone line
jack. Contact your DSL/ADSL provider for details.
R Other telephone equipment may be interfering with this unit.
Disconnect the other equipment and try again.
R Depending on your phone service provider, the unit may
display the caller's information at the 2nd ring or later. Set the
first ring to "Off" (page 19).
R Move closer to the base unit.
Useful Information
,
) and the charge contacts with
6/9/2016 3:19:58 PM
31
Advertisement
Table of Contents
