Brother Innov-Is NV2600 Operation Manual page 200

Troubleshooting
Symptom
Pattern adjustment settings were set incorrectly. Revise the pattern adjustment settings.
Character or
decorative patterns
are misaligned.
Wrong presser foot was used.
Pattern does not
turn out.
Did not use a stabilizer material on thin fabrics
or stretch fabrics.
Thread tension is set incorrectly.
Fabric was pulled, pushed or fed at an angle
while it was being sewn.
The thread is tangled, for example, in the
bobbin case.
Thread is twisted.
Embroidery pattern
does not sew out
correctly.
Thread tension is set incorrectly.
Fabric was not inserted into the frame correctly
(fabric was loose, etc.).
Stabilizing material was not attached.
There was an object placed near the machine,
and the carriage or embroidery frame hit the
object during sewing.
Fabric outside the frame edges interferes with
the sewing arm, so the embroidery unit cannot
move.
Fabric is too heavy, so the embroidery unit
cannot move freely.
Fabric is hanging off the table.
Fabric is snagged or caught on something.
Embroidery frame was removed during sewing
(for example, to reset the bobbin). The presser
foot was bumped or moved while removing or
attaching the embroidery frame, or the
embroidery unit was moved.
Stabilizer is incorrectly attached, for example, it
is smaller than the embroidery frame.
The thread tension is incorrectly set.
Loops appear on
the surface of the
The combination of the bobbin case and bobbin
fabric when
thread is incorrect.
embroidering.
A-18
Probable Cause Remedy
Attach the correct presser foot.
Attach a stabilizer material.
Adjust the thread tension.
Sew while guiding the fabric with your hands so
that the fabric is fed in a straight line.
Remove the tangle thread. If the thread is
tangled in the bobbin case, clean the race.
Use scissors, etc., to cut the twisted thread and
remove it from the bobbin case, etc.
Adjust the thread tension.
If the fabric is not taut in the frame, the pattern
may turn out poorly or there may be shrinkage
of the pattern. Set the fabric into the frame
correctly.
Always use stabilizing material, especially with
stretch fabrics, lightweight fabrics, fabrics with
a coarse weave, or fabrics that often cause
pattern shrinkage. See your authorized Brother
dealer for the proper stabilizer.
If the frame bumps something during sewing,
the pattern will turn out poorly. Do not place
anything in the area where the frame may bump
it during sewing.
Reinsert the fabric in the embroidery frame so
that the excess fabric is away from the sewing
arm, and rotate the pattern 180 degrees.
Place a large thick book or similar object under
the arm head to lightly lift the heavy side and
keep it level.
If the fabric is hanging off the table during
embroidery, the embroidery unit will not move
freely. Place the fabric so that it does not hang
off the table or hold the fabric to keep it from
dragging.
Stop the machine and place the fabric so that it
does not get caught or snagged.
If the presser foot is bumped or the embroidery
unit is moved during sewing, the pattern will not
turn out. Be careful when removing or
reattaching the embroidery frame during
sewing.
Attach the stabilizer correctly.
Adjust the thread tension.
Change the bobbin case or bobbin thread so
that the correct combination is used.
Reference
D-5
B-34
D-4
B-41
B-35
A-2
A-8
B-41
B-58
B-57
B-56
B-58
–
B-56
–
B-61
B-57
E-26
B-56