Power Connection - Raymarine E32158 Installation Instructions Manual

Note: The wire colors on your Multifunction display may differ
to that shown above if this is the case then ensure you have
connected the correct signals (e.g. IN - on the AIS connects to
OUT - on your Multifunction display and so on).
Connecting SeaTalk
The SeaTalk connector enables you to connect the AIS unit,
ng
aboard vessels on which the multifunction displays are connected
via SeaTalk .
ng
Before connecting to SeaTalk
Manual, and ensure that with this product connected, the maximum
permitted Load Equivalence Number (LEN) value for the system will
not be exceeded.
Note: Your AIS unit has a SeaTalk
1. Connect the supplied SeaTalk
SeaTalk connector.
ng
2. Connect the other end of the SeaTalk
place on your vessel's SeaTalk
i. Connect using SeaTalk
ii. Connect using a SeaTalk
iii. Connect using a spare SeaTalk
converter.
AIS350 Receiver
ng
, refer to the SeaTalk Reference
ng ng
LEN value of 1.
ng
spur cable to the AIS unit's
ng
spur cable to a suitable
ng
network as follows:
ng
5–way connector.
ng
T-Piece connector.
ng
spur on a SeaTalk
ng

2.7 Power connection

Power supply protection
Always protect the power supply by connecting the red (positive)
wire to the supply via a 2 A fuse or equivalent automatic circuit
breaker.
Sharing a breaker
Where more than 1 piece of equipment shares a breaker you must
provide protection for the individual circuits. E.g. by connecting an
in-line fuse for each power circuit.
ng
23