Table of Contents
Advertisement
CU1526, CU2026, CU3030
User Manual
Use and Operation
Once started, the ice machine will automatically
make ice until the curtain is held open by the ice at
the top of the pile. The typical ice level when the
machine is off will be several inches below the door
sill. When ice level drops from use or meltage, the
ice machine will resume making ice. If a small
cluster of ice is holding the curtain open, open the
curtain slightly to release it. The machine should
resume making ice in a few minutes.
Tip: Scoop the ice to the front and back of the bin
to maximize storage.
There are four indicator lights under the bin that
provide information on the condition of the
machine.
Indicator Lights:
•
Power, Status, Water De-scale & Sanitize
Power
Steady Green
Normal
Self Test
Blinking Green
Failure
Blinking Red
-
Yellow
-
Blinking
-
Yellow
Light Off
No power
If the Water light is on, the machine has sensed a
lack of water. Check the water supply to the
machine. The water could have been shut off or the
water filter cartridges might need to be changed.
If the De-Scale light is on, the machine has
determined that it needs to be cleaned. Contact an
authorized Scotsman service agent and have the
machine cleaned, de-scaled and sanitized.
Indicator Lights & Their Meanings
Status
Normal
Switching on or off
Diagnostic shut down, or, if making
ice, temperature sensor failure
-
-
Switched off
Note: A Component Indicator Light switches ON to
indicate that the component is operating.
Note: There are two Curtain Switch lights, SW1 and
SW2. These single plate models have one curtain
switch light on all the time, as a curtain switch light
is ON when a curtain is either open or not present.
March 2017
Page 12
De-Scale &
Water
Sanitize
-
-
-
-
Lack of
-
water
Time to de-scale
-
and sanitize
-
In Cleaning mode
Normal
Normal
Advertisement
Table of Contents
