Table of Contents
Advertisement
CHAPTER 4: USEFUL HELP
4.1
A
BIOS B
WARD
Beep Sound
One long beep followed by two short
beeps
High-low siren sound
One Short beep when system
boot-up
Long beeps every other second
4.2
T
ROUBLESHOOTING
Probable
1.
No power to the system at all
Power light don't illuminate, fan
inside power supply does not
turn on.
2.
Indicator light on keyboard does
not turn on.
System inoperative. Keyboard lights
are on, power indicator lights are lit,
and hard drive is spinning.
System does not boot from hard disk
drive, can be booted from optical
drive.
System only boots from optical drive.
Hard disk can be read and
applications can be used but booting
from hard disk is impossible.
Screen message says "Invalid
Configuration" or "CMOS Failure."
Cannot boot system after installing
second hard drive.
K
8
N
H
A
G
r
a
n
d
K
8
N
H
A
G
r
a
n
d
C
EEP
ODE
Video card not found or video card
memory bad
CPU overheated
System will shut down automatically
No error found during POST
No DRAM detected or install
1.
Make sure power cable is
securely plugged in.
2.
Replace cable.
3.
Contact technical support.
Using even pressure on both ends of
the DIMM, press down firmly until the
module snaps into place.
1.
Check cable running from disk to
disk controller board. Make sure
both ends are securely plugged
in; check the drive type in the
standard CMOS setup.
2.
Backing up the hard drive is
extremely important. All hard
disks are capable of breaking
down at any time.
Back up data and applications files.
Reformat the hard drive. Re-install
applications and data using backup
disks.
Review system's equipment. Make
sure correct information is in setup.
Set master/slave jumpers correctly.
Run SETUP program and select
correct drive types. Call the drive
manufacturers for compatibility with
other drives.
17
Meaning
Solution
Advertisement
Table of Contents
