Table of Contents
Advertisement
11
ADJUSTING THE TENSION OF BLADE
Blade tension is set by a spring loaded tension
mechanism on the upper wheel. Check the level of the
tension device before cutting. The tension for various
blade widths as indicated on the window of upper
wheel cover.
Turn the blade tension hand wheel (see Figure 10) and
see the saw tension instruction (see Figure 11)
indicated on the window of upper wheel cover.
ADJUSTING UPPER BLADE GUIDE
ASSEMBLY
1. Set the bearing of upper and lower blade guide
within approx. 0.5mm of the blade. Make sure the
bearing and the back of the blade approx. 0.5mm.
(see Figure 12 and Figure 13)
2. Do not set the bearing too close. The friction
generates heat, which may have an adverse effect
on the bearings and the saw blade.
DUST COLLECTION
The band saw is recommended to be connected to dust
collect. There are two 4" dust ports (see Figure 14) to
attach with 4" steel clamping.
SETTING THE CUTTING HEIGHT
The upper blade guide should always be set as close
practical against the work. To adjust, loosen the hand
wheel (see Figure 15) at the side of housing and see
the blade guide to the required height. Then, tighten
after setting.
Instructions Manual for BP-480 (W4346)
Figure 10
Figure 12
8
04/11/2019
Figure 11
Figure 13
Figure 14
Figure 15
Advertisement
Table of Contents
