Table of Contents
Advertisement
OPERATION MANUAL
4. ADJUSTMENTS
WARNING: Always be sure that the machine is
switched off and unplugged before any
adjustment is commenced.
4.1 TILTING TABLE
Loosen the locking handle and adjust the table to
the desired angle.
Use the angle indicator scale to find the desired
angle. The scale is only used as a guide. For very
accurate angle use a protractor against the blade.
Re-tighten the locking handle to secure the table.
Locking Handle
Fig. 4.1
4.2 BLADE TRACKING
If the saw blade does not run in the center of the rubber tyre, the tracking needs to be correct-
ed by adjusting the tilt of the upper band saw wheel. To adjust the tracking open the upper
and lower covers.
Loosen the tracking lock lever,(Fig. 4.3) manually rotate the upper wheel, taking care no to
touch the blade.
Turn adjusting knob clockwise or anticlockwise until the saw blade tracks centered on the rub-
ber tyre. After adjusting, re-tighten the tracking lock lever and close the cover.
Locking
Lever
Adjusting
Knob
Fig. 4.2
Fig. 4.3
15
Advertisement
Table of Contents
