Cleaning The Pre-Filter - Philips 6000i Series User Manual

1
Switch off the air purifier and unplug
from the power socket.
2
Clean the air quality sensor inlet
and outlet with a soft brush (fig.x).
3
Open the air quality sensor cover
(fig.y).
4
Clean the air quality sensor, the
dust inlet and the dust outlet with a
damp cotton swab (fig.z).
5
Dry all parts thoroughly with a dry
cotton swab.
6
Reattach the air quality sensor
cover (fig.{).

Cleaning the pre-filter

Clean the pre-filter when F0 is displayed
on the screen and the pre-filter cleaning
alert is on (fig.|).
1
Switch off the air purifier and unplug
from the power socket.
2
Pull the top part of the side panel
to remove it from the air purifier
(fig.c).
3
Press the two clips down (1) and pull
the pre-filter towards you (2) (fig.d).
4
If the pre-filter is very dirty, use a
soft brush to brush away the dust.
Then wash the pre-filter under
running tap water (fig.}).
5
Allow the pre-filter to air dry
thoroughly before placing back in
the air purifier.
12 EN
6
Put the pre-filter back into the air
purifier (fig.h).
Note
• To optimize the lifetime of the pre-
filter, make sure it air dries completely
after cleaning.
• Wash your hands after handling the
filter.
• Make sure the side with the two clips
is pointing towards you, and that all
hooks of the pre-filter are properly
attached to the air purifier.
7
To reattach the front panel, press
the top part of the panel onto the
top of the air purifier (1). Then, gently
push the panel against the body of
the air purifier (2) (fig.i).
8
Put the plug of the air purifier in the
power socket.
9
Touch the button to switch on the
appliance.
10
Touch and hold the reset button
for 3 seconds to reset the pre-filter
cleaning time.
11
Wash your hands thoroughly after
installing filters.