Atag VA5114MT User Manual page 39

Num‐ Settings
ber
3 End sound
4 Auto door
open
5 Key tones
6 Latest pro‐
gramme selec‐
tion
1) For more details, refer to the information provided in this chapter.
You can change the basic settings in
setting mode. Instructions on how to
configure the appliance are provided
further in this chapter.
When the appliance is in setting mode, the
display shows a digit and a letter. For
each setting, a dedicated letter is
displayed. The dedicated letters are
indicated in the table.
The order of the basic settings presented
in the table is also the order of the settings
in setting mode.
The water softener
The water softener removes minerals from
the water supply, which would have a
Water hardness
German de‐
grees (°dH)
47 - 50
43 - 46
37 - 42
29 - 36
23 - 28
Values
1b (on)
0b (off)
1o (on)
0o (off)
1F (on)
0F (off)
1H (on)
0H (off)
French de‐
grees (°fH)
84 - 90
76 - 83
65 - 75
51 - 64
40 - 50
1)
Description
Activate or deactivate the acoustic signal for
the end of a programme.
Factory setting: 0b.
Activate or deactivate the AirDry.
Factory setting: 1o.
Activate or deactivate the sound of the but‐
tons when pressed.
Factory setting: 1F.
Enable or disable the automatic selection of
the most recently used programme and op‐
tions.
Factory setting: 0H.
negative effect on the washing results and
on the appliance.
The higher the content of these minerals,
the harder your water is. Water hardness
is measured in equivalent scales.
The water softener should be adjusted
according to the hardness of the water in
your area. Your local water authority can
advise you on the hardness of the water in
your area. It is important to set the right
level of the water softener to assure good
washing results.
mmol/l Clarke de‐
grees
8.4 - 9.0 58 - 63
7.6 - 8.3 53 - 57
6.5 - 7.5 46 - 52
5.1 - 6.4 36 - 45
4.0 - 5.0 28 - 35
39
Water softener
level
10
9
8
7
6