Table of Contents
Advertisement
9.
Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor
or switch. Connect one end of the chassis intrusion sensor or switch
cable to this connector. The chassis intrusion sensor or switch sends
a high-level signal to this connector when a chassis component
is removed or replaced. The signal is then generated as a chassis
intrusion event.
By default , the pin labeled "Chassis Signal" and " Ground" are shorted
with a jumper cap. Remove the jumper caps only when you intend to
use the chassis intrusion detection feature.
Chassis Intrusion Connector
10. IEEE 1394a port connector (10-1 pin IE1394_2)
This connector is for a IEEE 1394a port. Connect the IEEE 1394a
module cable to this connector, then install the module to a slot
opening at the back of the system chassis.
IEEE 1394a Connector
The IEEE 1394a module is purchased separately.
ASUS V-Series P5G965
CHASSIS
(Default)
IE1394_2
1
4-11
Advertisement
Table of Contents
