Table of Contents
Advertisement
Appliance settings
en
Programme end
"Ÿš lights up on the display and À and
Õ displays are off.
If you have selected 2, the water is only
drained after rinse process, no spin
cycle.
Notes
If •©£ flashes in the display before
■
the drying programme ends, the
temperature in the drum is high. The
programme for cooling the drum
runs until the temperature in the
drum has dropped.
If you do not take laundry out within
■
15 mins after drying process
finished, wrinkle guard process will
start to prevent laundry getting
wrinkled. The process lasts about 30
minutes. 0:00, £'˜, £© and "Ÿš will
be displayed alternately on the
display and Ó symbol will be
displayed as the status symbol. You
can touch any button to terminate
this process, then the door will be
released and laundry can be taken
out.
Removing laundry/switching
off the appliance
Set programme selector to Û (Off).
1.
Open the door and remove the
2.
laundry.
Turn off the water tap.
3.
Not required for Aqua-Stop
Note:
models.
Notes
Do not leave any items of laundry in
■
the drum. They may shrink in the
next wash or discolour another item.
Remove any foreign objects from the
■
drum and the rubber seal – risk of
rusting.
40
Wipe the rubber seal dry.
■
Leave the door and detergent
■
drawer open so that any residual
water can evaporate.
Always wait until the programme
■
ends, as the appliance could still be
locked. Then switch the appliance
on and wait for it to unlock.
Q
Appliance settings
Y ou can change the following settings:
A p p l i a n c e s e t t i n g s
The volume of the end signal.
■
The volume of the button signal.
■
Switching the drum care information
■
signal on/off.
You will need to activate the setting
mode in order to change these settings.
1/2/3/4...
positions on the
programme selector
Advertisement
Table of Contents
