Table of Contents
Advertisement
Connecting External SCSI Devices
1
Be sure that each external SCSI device you are installing has a
unique SCSI ID from 0 to 6. Refer to the SCSI device's docu-
mentation to determine the SCSI ID setting.
If any two SCSI devices (external or internal) you are connect-
ing to the SCSI Card 2906 have the same SCSI ID, change the
SCSI ID on one SCSI device. The SCSI Card 2906 is preset to
SCSI ID 7 and should not be changed.
For most external SCSI devices, the SCSI ID is set with a switch
on the back of the SCSI device as shown below. See the SCSI
Card 2906 User's Reference for additional information on SCSI
IDs.
2
Connect one end of the external SCSI cable to the SCSI Card
2906 external SCSI connector as shown in the following dia-
gram. Secure the cable to the connector on the SCSI Card 2906
by tightening the thumb screws on the cable connector.
SCSI Card 2906
SCSI ID Switch
11
Advertisement
Table of Contents
