Setting The Oven; This Is How You Adjust The Lower Gas Burner In The Oven; Procedure For Setting The Gas Grill - Bosch HGA243255M Instruction Manual

Setting the oven

Here you can find out how to set the oven.
This is how you adjust the lower gas burner in
the oven
When the lower gas burner is lit, you can bake on a baking
sheet with the oven door closed.
Example in the picture: Baking at 170 °C
Open the top cover. The top cover must remain open for as
1.
long as the oven is in operation.
Open the main gas supply to the appliance. Connect the plug
2.
to the socket. Open the oven door.
Press the function selector and turn it anti-clockwise to the
3.
ignition position.
8
The gas escaping from the oven's lower gas burner is ignited
using the ignition button.
Continue to hold the function selector depressed and turn it
4.
to 170 °C.
To activate the safety ignition, press and hold the function
selector for 10 seconds.
Look through the inspection port to make sure that the flame
5.
is lit. If it is not, repeat the process from step 3.
Close the oven door slowly.
6.
Preheat the empty oven for approximately 15 minutes before
7.
baking.
When the dish has finished cooking, switch the function
8.
selector off.
You can change the temperature at any time.
:
Please note:!
The ignition device should not be actuated for more than 15
seconds. If the burner does not light within 15 seconds, wait for
at least one minute. Then repeat the ignition process.
14
Pans should be placed on the
hob carefully.
Do not strike the hob and do
not place excessive weight on
it.

Procedure for setting the gas grill

Open the top cover. The top cover must remain open for as
1.
long as the oven is in operation.
Turn on the main gas supply to the appliance. Connect the
2.
plug to the socket.
Insert the protecting plate into the groove under the control
3.
panel.
The protecting plate is inserted with the longer edge facing
forwards and the curvature facing downwards.
Fasten the protecting plate in the groove under the control
panel using the retainers.
Make sure that the protecting plate is latched into the
retainers. Once the protecting plate cannot be removed, it is
correctly latched in place. You can now safely use the
protecting plate. If it can be removed, insert it into the groove
at a slightly higher angle and make sure that it latches into
the retainers.
Close the oven door so that it is in contact with the protecting
4.
plate.
Press the function selector and turn it clockwise into the
5.
ignition position .
8
Keep the function selector pressed in and turn to the grill
6.
setting .
(
To ensure that the ignition safety system responds, press and
hold the function selector for 10 seconds. The gas leaving
the gas grill will be ignited.
Check whether the flame is lit. If the flame is not lit, repeat the
7.
process from step 5.
Once the meal is cooked, switch off the function selector.
8.
Once the oven has cooled down, remove the protecting
plate.
Never use two burners or heat
sources to heat one single
pan.
Do not use grill pans,
earthenware casserole dishes,
etc. for a long period of time
on maximum power.