Procedure For Setting The Gas Grill; Cleaning The Accessories; Making Settings On The Hob; Advance Cleaning Of Burner Cup And Cap - Bosch HGA243255M Instruction Manual

Procedure for setting the gas grill

Open the top cover. The top cover must remain open for as
1.
long as the oven is in operation.
Turn on the main gas supply to the appliance. Connect the
2.
plug to the socket.
Insert the protecting plate into the groove under the control
3.
panel.
The protecting plate is inserted with the longer edge facing
forwards and the curvature facing downwards.
Fasten the protecting plate in the groove under the control
panel using the retainers.
Make sure that the protecting plate is latched into the
retainers. Once the protecting plate cannot be removed, it is
correctly latched in place. You can now safely use the
protecting plate. If it can be removed, insert it into the groove
at a slightly higher angle and make sure that it latches into
the retainers.
Close the oven door so that it is in contact with the protecting
4.
plate.

Making settings on the hob

Your hob is equipped with four gas burners. The following
information explains how to light the gas burners and set the
size of flame.

Advance cleaning of burner cup and cap

Clean the burner cap (1) and cup (2) with water and washing-
up liquid. Dry the individual parts carefully.
Place the burner cup and cap back on the burner shell (5).
Ensure that the igniter (3) and flame safety pin (4) are not
damaged.
The nozzle (6) must be dry and clean. Always position the
burner cap exactly over the burner cup.

Igniting the gas burners

Always position the burner cap exactly onto the burner cup. The
openings in the burner cup must remain unobstructed at all
times. All parts must be dry.
Open the upper cooker cover. The upper cover must remain
1.
open whilst the cooker is in operation.
Turn the control for the required hotplate anti-clockwise to the
2.
ignition position 8 . This starts the ignition process.
12
Press the function selector and turn it clockwise into the
5.
ignition position .
8
Keep the function selector pressed in and turn to the grill
6.
setting .
(
To ensure that the ignition safety system responds, press and
hold the function selector for 10 seconds. The gas leaving
the gas grill will be ignited.
Check whether the flame is lit. If the flame is not lit, repeat the
7.
process from step 5.
Switch off the function selector after 30 minutes. Once the
8.
oven has cooled down, remove the protecting plate.
Caution!
The gas grill only works when the protecting plate is inserted.
Make sure that the protecting plate is correctly inserted.

Cleaning the accessories

Before you use the accessories for the first time, clean them
thoroughly with hot soapy water and a soft dish cloth.
Press and hold the hotplate control for 1-3 seconds. Gas
3.
begins to flow out and the gas burner ignites.
The safety pilot is activated. If the gas flame goes out, the gas
supply is automatically cut off by the safety pilot.
Set the required flame size. Between the Off
4.
— setting, the flame is not stable. Therefore, always choose a
setting between the large flame
If the flame goes out again, repeat the process from step 2.
5.
To finish cooking, turn the hotplate control clockwise to the
6.
Off position.
þ
The hotplate control should not be turned to the ignition
position for longer than 15 seconds. If the burner does not light
within 15 seconds, wait at least one minute. Then repeat the
ignition process.
:
Caution!
If, after switching the cooker off, you turn the burner control
while the cooker is still hot, gas will escape. If you do not turn
the hotplate control to the ignition position
seconds, the gas supply will be cut off.
þ setting and the
— and small flame ˜ .
8 within 60