Wattage Calculations - King Canada KCG-1501GN Instruction Manual

WATTAGE CALCULATIONS

IMPORTANT! Never exceed the rated capacity of your generator. Seri-
ous damage to the generator or appliance could result from an over-
load.
1) "Starting" and "Running" wattage requirements should always be
calculated when matching a generators wattage capacity to the
appliance or tool.
2) There are two types of electrical appliances that can be powered by
your generator;
a) Items such as radios, light bulbs, televison sets, and microwaves
have a "resistive load". Starting wattage and running wattage are the
same.
b) Items such as refrigerators, air compressors, washer, dryer and hand
tools that use an electrical motor have an "inductive load". Inductive
load appliances and tools require approx. 2 to 3 times the listed
wattage for "starting" the equipment. This
for a few seconds on start-up but is important when figuring your total
wattage to be used.
Always start your largest electric motor first, and then plug in other
items, one at a time.
NOTE: On 120-volt loads the maximum starting wattage should NOT
exceed one half of the rated generator wattage.
Example: 5000 Wattage rated generator = 2500 maximum starting
wattage.
Wattage Requirement Chart below- This is only a guideline, each ap-
pliance or electrical device needs to be checked for its specific operat-
ing load.
WATTAGE CALCULATIONS
initial load only lasts
DETERMINING WATTAGE REQUIREMENTS
Note: Volts X Amps = Watts
Example: 120V X 12 Amps = 1400 Watts
Before operating this generator, list all of the appliances and/or tools
that are going to operate at the same time. (Then determine the starting
wattage requirements and the running wattage requirements by follow-
ing the example below;
1) Add the total amount of the running wattage of all appliances and/or
tools that will be operated at the same time.
Example 1A:
Lights = 100 Watts (Running)
Television = 300 Watts (Running)
TOTAL = 400 Watts (Running)
2) Next add the total amount of the starting wattage of any appliances
and/or tools that will start and stop during operation.
Example 1B:
Small Refrigerator = 500 Watts (Running) 2000 Watts (Starting)
TOTAL = 500 Watts (Running) 2000 Watts (Starting)
3) The running wattage of examples 1A & 1B totals 900 watts. The start-
ing wattage totals 2000 watts which is 1500 watts more than the running
watts. Take this difference of 1500 starting watts and add to the total
running watts of 900. Therefore:
1500 Starting Watts + 900 Running Watts = 2400 Total Watts
The generator required to operate the items in example 1A & 1B
must have a minimum capacity of at least 2400 starting watts.