Troubleshooting; Specifications/ Technical Data - Maruyama MAG500 Owner's/Operator's Manual

Troubleshooting

Problem
Engine will not start
Engine will not Idle
Engine lacks power or
stalls when cutting
If further assistance is required, contact your local authorized MARUYAMA service dealer.
Specifications
Engine displacement, cm
-1
Idling speed, min
Maximum engine power, according to ISO 8893, kW
Spark plug
Electrode gap, mm
Type of carburetor
Fuel tank capacity, liters
Weight without fuel and drill , kg
Adaptable drill size Diameter, mm
Technical data
Noise levels
Equivalent sound pressure level (L
Guaranteed sound power level(L
2000/14/EC, dB(A)
Equivalent sound power level(L
Vibration values
Vibration values on the handles measured according to ISO 8662, m/s
φ150 drill, a / A(8):
hv,eq
Cause
・Stop switch set to STOP position
・Empty fuel tank
・Primer bulb wasn't pushed enough
・Engine flooded
・Idle speed set incorrectly
・Throttle wire has come loose
・Dirty air filter
3
), measured according to ISO11201, dB(A)
pAeq
), determined according to directive
WAG
), measured according to ISO3744, dB(A)
WA
・Move switch to RUN position
・Fill fuel tank
・Press primer bulb until fuel flows
・Use warm engine starting procedure
・Set Idle speed
・Tighten throttle wire
・Clean or replace air filter
2
－ 14 －
Action
MAG500/ MAG500RS
49,9
2600
1,91
NGK BPMR6Y
0,6-0,7
Diaphragm
1,0
10,0/ 10,2
40 to 200
97,5
112
108
14,8/ 9,1