Related Manuals for Maruyama MAG500
Summary of Contents for Maruyama MAG500
- Page 1 Earth Auger MAG500 MAG500RS US Owner’s/Operator’s Manual Completely read and understand this manual before using this product. － 0 －...
-
Page 2: Table Of Contents
Earth Auger. It is essential that any operator of this Earth Auger reads and understands the contents this manual before using the Earth Auger. For additional assistance, contact any local authorized MARUYAMA dealer. Contents Page Page Foreword ……………………………………………... -
Page 3: Safety Instructions
Safety decals ON FRAME ON FRAME (Part No. 229951) (Part No. 228043) ON ENGINE (Part No. 265694) Safety Decals are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. Safety instructions The warning system in this manual identifies potential hazards and has special safety messages that help you and others avoid personal injury, even death. -
Page 4: Earth Auger Safety
6. Make sure the drill is installed and positioned correctly before using the Earth Auger. 7. Never use a drill or replacement parts that are not approved by MARUYAMA. 8. Maintain the Earth Auger according to the recommended maintenance intervals and procedures in the Maintenance section beginning on page 11. -
Page 5: Symbol Explanation
10. Keep a firm footing and balance. Do not overreach. 11. Use the right tool for the job. Do not use the Earth Auger for any job that is not recommended by MARUYAMA. Symbol explanation Indicates Danger, Warning, Caution. -
Page 6: Assembly
Assembly Installing left grip Screw in the left grip to the bracket provided on the frame and tighten securely. Left grip Installing drill 1. Slide the ring clip and remove the lock pin from the drill. 2. Put the drill onto the auger output shaft and insert the lock pin. Cover it with the ring clip. -
Page 7: Before Operation
Before operation Oil and fuel 1. Mix and pour fuel outdoors and where there are no sparks or flames. 2. Always shut off the engine before refueling. Never remove the Earth Auger fuel tank cap while the engine is running or immediately after stopping the engine. ... -
Page 8: Mixing Gasoline And Oil
Recommended fuel type Use clean, unleaded gasoline with an octane rating of 85 or higher. Use of unleaded gasoline results in fewer combustion chamber deposits and longer spark plug life. Use of premium grade fuel is not necessary or recommended. IMPORTANT: Never use gasohol or alcohol blended fuels in this engine. -
Page 9: Starting And Stopping
Starting and stopping The drill will start moving upon the engine starts. Before starting the engine 1. Fill the fuel tank as instructed in the Before Operation section of this manual. 2. Rest the Earth Auger on the ground. 3. Make sure the drill is clear of any broken glass, nails, wire, rocks or other debris. -
Page 10: Idle Speed Adjustment
・ Turn the screw out (counterclockwise) to decrease the engine idle speed. If idle speed adjustment is necessary, and after adjustment the drill rotates or the engine stalls, stop using the Earth Auger immediately! Contact your local authorized MARUYAMA Dealer for assistance and servicing. － 9 －... -
Page 11: Operation
Operation CAUTION ・ Read the Safety instructions beginning on page 2 concerning proper use of the Earth Auger. ・ Always wear gloves and protective clothing when operating the Earth Auger. Drilling • Keep a firm grip of the auger at all times on a wide stance and by holding the handle with both hands. -
Page 12: Maintenance
Maintenance Air filter Maintenance interval Filter Cover ・The air filter should be cleaned daily, or more often when working in extremely dusty conditions. ・Replace after every 100 hours of operation. Foam Element Air filter cleaning 1. Remove the foam element. 2. -
Page 13: Spark Plug
Spark plug Maintenance interval ・The spark plug should be removed from the engine and checked after each 25 hours of operation. ・ Replace the spark plug after every 100 hours of operation. Spark plug maintenance 1. Twist the high tension lead boot on the spark plug back and 0,6 - 0,7 mm forth a couple of times to loosen the boot, then pull the boot off of the spark plug. -
Page 14: General Cleaning And Tightening
・Always turn off your Earth Auger before you clean or perform any maintenance on it. The MARUYAMA Earth Auger will provide maximum performance for many, many hours if it is maintained properly. Good maintenance includes regular checking of all fasteners for correct tightness, and cleaning the entire machine. -
Page 15: Troubleshooting
・Tighten throttle wire Engine lacks power or stalls when cutting ・Dirty air filter ・Clean or replace air filter If further assistance is required, contact your local authorized MARUYAMA service dealer. Specifications MAG500/ MAG500RS Engine displacement, cm 49,9 Idling speed, min... - Page 16 P/N.238185-00 US 1509 － 15 －...