Starting And Stopping - Maruyama MAG500 Owner's/Operator's Manual

Starting and stopping

The drill will start moving upon the engine starts.
Before starting the engine
1. Fill the fuel tank as instructed in the Before Operation section of
this manual.
2. Rest the Earth Auger on the ground.
3. Make sure the drill is clear of any broken glass,
nails, wire, rocks or other debris.
4. Keep all bystanders, children and animals away from the working
area.
Cold starting procedure
The carburetor on this engine is equipped with a fuel primer and a
choke system.
To start a "cold" engine properly, perform the following procedure:
1. Pump the primer bulb until fuel can be seen flowing through
the fuel return line to the fuel tank. Flowing fuel should be
almost clear, not foamy or full of bubbles.
2. Turn the choke lever to the close position.
3. With the stop switch "RUN", pull the starter grip .
4. While holding the unit firmly, pull out the starter grip quickly
until engine started.
(a) Hold the right grip with your left hand.
(b) Support the left grip with your waist.
(c) Do not press the drill on the ground.
After the engine is started, turn the choke lever to the
Open position.
If the engine stops running before you turn the choke lever to
the open position :
Go ahead and open the choke, pull the starter grip quickly until
engine started.
(4)
－ 8 －
(1) Primer Pump
(2) Fuel Return Line
(1)
(1)Choke lever
(2)Close
(3)Open
(4) Starter grip
(1) Stop Switch
(1)
(2)