G4101
Be sure to round off the front edge to reduce
the chance of kickback or tie-strap breakage.
Make sure every cutter has the same length and edge
angles as illustrated.
Cutter length
■ Guide Bar
• Reverse the bar occasionally to prevent partial
wear.
• The bar rail should always be square. Check for wear
of the bar rail. Apply a ruler to the bar and the outside
12. Troubleshooting Guide
Case 1. Starting failure
Make sure the icing prevention system is not
working.
Check fuel for water
or substandard mix-
ture.
➡
C h e c k f o r e n g i n e
flooding.
➡
Check spark ignition.
Case 2. Lack of power/Poor acceleration/
Rough idling
Check fuel for water or
substandard mixture.
➡
Check air filter and
fuel filter for clog-
ging.
➡
Check carburetor for
inadequate adjust-
ment.
GB-14
01-G4101_GB_306_三.indd 14
Filing angle
Side plate angle
Top plate cutting angle
➡
Replace with proper
fuel.
Remove and dry the
spark plug.
➡
Then pull the starter
again with no choke.
Replace with a new
➡
plug.
Replace with proper
➡
fuel.
➡
Clean.
Readjust speed nee-
➡
dles.
of a cutter. If a gap is observed between them, the
rail is normal. Otherwise, the bar rail is worn. Such a
bar needs to be corrected or replaced.
Ruler
Gap
No gap
Chain tilts
WARNING:
This saw is equipped with one of the following low kick-
back bar/chain combinations:
Saw Model Chain Type
16" 2939-52111 577266101
G4101
95VPX
18" 848CB48P11 577266201
Case 3. Oil does not come out
Check oil for substan-
➡
dard quality.
➡
Check oil passage
➡
and ports for clog-
ging.
If the unit seems to need further service, please consult
with an authorized service shop in your area.
13. Disposal
• When you dispose of the machine, do not disas-
semble the machine.
• When you dispose of the machine, fuel, chain oil,
be sure to follow your local regulations.
Zenoah Part Number
Guide Bar
Saw Chain
Replace.
Clean.
13.6.25 5:29:15 PM