Wash Options - LG LD-4031W1 Owner's Manual

WASH OPTIONS

Before selecting the wash program, press the power button. Then Normal program
will be selected with remaining time on display window. To change the program,
press the program button required.
Start / Pause Button
After selecting a wash program, press the Start or
Pause button to start the wash cycle.
If at any time you want to interrupt the washing
cycle, press the Start or Pause button. Your
dishwasher will then pause. Press the Start or
Pause button again to re-start dishwasher.
The Dishwasher will turn off Automatically if
Paused for longer than 5 minutes.
Progress Indicators
Once you select a program, the progress indicators
light(Wash, Rinse, Dry). When press the Start or
Pause button to start the program, the current stage
light will blink.
Delay Start
This function enables the wash cycle to start
anywhere between 1 to 19 hours later.
Select the program that you want by using the
program button.
Set the delay time you want by pressing the
"Delay Start" button. The delay start time is
increased by 1 hour each time the Delay button
is pressed.
Press the start button. Then the program will be
started automatically after the delayed time
shown in the display has expired.
Rinse Plus
Normally when you select any program, the Rinse
process is done only two ( 1 normal rinse +1
heating rinse) or three (2 normal rinse + 1 heating
rinse) times according to selected program. But if
you want to rinse more, you can use this function.
As you select R +1 by pressing Rinse button, an
additional rinse is added to the rinse process.
Child Lock
To reduce the possibility of children interrupting
the dishwasher when unattended, the child lock
feature can be selected.
For locking or unlocking, press "Delay Start"
and "T-Save" buttons simultaneously during the
wash cycle operation.
The Child lock cannot be set whilst the unit is off
or in a paused mode. It can only be set after the
wash cycle has started.
Sani-Rinse
When you want to rinse dishes with higher
temperature for sanitation, use this function. The
Sani-Rinse will not operate in Quick program. If
you choose this function, the water temperature
goes up to 77˚C when rinsing.
Press Rinse button until "R
Half Load
With each press, upper rack only(Upper light on),
lower rack only(Lower light on) can be selected.
In case of small load washing, use upper or lower
rack only to save energy. The water consumption
will remain the same.
At the end of the washing
program
" " is displayed on the digital display and a
buzzer sounds. The display then shows "
indicate that the dishwasher is in "Cool dry"
mode.
Cool dry-"Cd"
This process is not part of the program.
At the end of the program, the fan will continue to
operate for about an hour to diminish any
remaining moisture.
If you want, you can now open and unload the
dishwasher. Otherwise the dishwasher
automatically switches off for safety and energy
saving later.
16
˚ " is indicator is lit up.
77
" to