Advertisement
Important:
Before starting the machine make sure that the
area is clear from obstacles and people.
Do not let people other than the operator, and
support personnel near the equipment including
the work area under demolition.
Operate the machine only on safe surfaces.
Look for and keep away from hazards such as
drop-offs.
Look behind when operating in reverse. Look for
people and hazards.
Operate the machine from the operator seat only.
only person that should start
The operator is the
the machine.
Do not operate on steep slopes.
Go slow on slick surfaces. Always keep a firm
grip on the controls.
Before leaving the operator seat;
Make sure controls are in the neutral position.
Turn the motor off, and let it come to a complete
stop.
Before attempting to maintain, adjust or service
the machine, put the controls in neutral, turn the
motor off, let it come to a complete stop, and
disconnect the machine from the electric power
supply.
Propane Machines,
Air Intake on front of machine, remove filter
and knock off or blow out debris several times
during the day when environment is dusty. It
may be advisable to purchase additional filter
elements in order to have a properly cleaned
filter element available on the job site (order part
# 260P.60.02.KIT).
Check the condition of the carburetor air filter
prior to operation each day that the machine is in
use and replace when necessary (order part #
260P.04.35 and pre filter #260P.04.35A).
Use only Taylor Tools accessories, attachments,
and replacement parts. Use of other components
may void warranty.
Storage:
If the machine is to be stored for an extended
period of time check for oil leaks and repair as
necessary before storage. Remove the transporta-
tion wheel and lower the blade holder on the
floor. Store the electrical cord on a cord reel or
in a protective container to avoid incidental
damage. Make sure machine is on level ground
and protect the machine from the outdoor ele-
ments such as rain and direct sunlight.
Cleaning:
It is important that when removing carpeting to
be careful not to let carpet yarn collect on the
rear wheel axle. If yarn builds up on the axle it
will fail the seal. When removing carpet keep
yarn scraps away from the rotating wheel. After
carpet removal check both rear axles for yarn
build up and remove as necessary.
Filter Maintenance;
Advertisement
