Advertisement
Control lever will not engage drive wheel
Machine moves forward or backward when
control levers are in the neutral position.
T
S
ROUBLE
HOOTING
o Check the linkage connection to the
pump control arm.
o Check belt tension and tighten if
necessary.
o Check hydraulic oil level.
o If there is a loud squeal coming from
the pump it may be caused by a loose
belt or a pump that has been run
without oil. If the later is the case the
pump must be replaced. Pump failure
due to running out of oil is not
covered by warranty.
o Put machine on a safe block to allow free
turning of the wheel to be adjusted
o Open machine hood, (see hood opening
procedure) and rotate the control lever
clock wise or counter clockwise until
wheel stops moving. Make sure that the
cable end (attached to the ball joint on
the control arm),does not unscrew from
the end of the cable when rotating the
control levers.
Advertisement
