Installing Acendo Vibe; Overview; Credenza Installation; Wall Mount Installation - Harman AMX ACENDO VIBE ACV-2100 Instruction Manual

Installing Acendo Vibe

Overview

This section describes the physical installation of the Acendo Vibe unit. Note that many of the mounting illustrations use
the ACV-5100 as an example, but these mounting instructions apply equally to the ACV-2100.
NOTE:
Do not lift the ACV-5100 by the camera or rest the ACV-5100 unit on the camera.

Credenza Installation

NOTE:
To ensure highest possible sound quality, the rubber feet on the bottom panel must remain in place for surface-
mount installations.
The Acendo Vibe can sit on a hard, flat surface such as a credenza, tabletop or desk. When choosing a surface location,
consider a space that will not interfere with workspaces or other installed devices. Connect cables as necessary - see the
Connections section on page 11 for details.

Wall Mount Installation

For best aesthetic in wall mount installations, remove the rubber feet from the bottom panel: carefully peel each foot off
of the bottom surface.

Removing the Wall Mount Bracket

1.
Open the Wall Mount Bracket (held closed by internal magnets).
2.
Press and hold the Release Button to slide the Bracket out (over the button) to disengage the pins on the Bracket
from the hinges on the unit (FIG. 6).
Wall Mount Bracket
FIG. 6
Acendo Vibe Bottom View - opening the wall mount bracket
3.
Lift the Wall Mount Bracket off of the hinges to remove (FIG. 7):
FIG. 7
Acendo Vibe Bottom View - removing the bracket

Wall Mount Considerations

Distance between conference table and display: The closer the table is to the wall-mounted display. the lower the

display should be mounted. As a general guide, the display should be mounted between 40" and 48" from the
floor (see FIG. 8 on page 9).
Avoid obstructing the camera view: If the display protrudes from the wall more than the Acendo Vibe, then

additional spacing between the display and the Acendo Vibe may be needed.
Position camera for full visibility: In small rooms, it may be necessary to manually tilt the camera up to maximize

visibility for all participants.
Acendo Vibe Conferencing Soundbars - User Guide
Hinges/Pins
Slide pins in to install
Wall Mount Bracket
Pins (x4)
Hinges (x4)
connector bay
Release Button
Installing Acendo Vibe
Release Button
Slide pins out to remove
8