Downloading The Phone Book; Selecting The Bluetooth Device You Wish To - Kenwood KDC-BT51U Instruction Manual

Function of KDC-BT51U, KCA-BT300/BT200 (Optional Accessory)
Bluetooth setup

Downloading the Phone book

Download the phone book data from the cell-
phone to this unit so that you can use the Phone
Book of this unit.
Downloading automatically
If the cell-phone supports a phone book
synchronization function, the phone book is
downloaded automatically after Bluetooth
connection.
⁄
•
Setting on the cell-phone may be required.
•
If no phone book data is found in the unit even after the
"Completed" is displayed, your cell-phone may not support
automatic download of phone book data. In this case, try
downloading manually.
Downloading from the cell-phone manually
1
Operate the cell-phone to end the hands-free
connection.
2
Operate the cell-phone to send the phone
book data to this unit
By operating the cell-phone, download the phone
book data to this unit.
• During downloading:
"Downloading" is displayed.
• After completion of downloading:
"Completed" is displayed.
3
Operate the cell-phone to start the hands-free
connection.
Clearing the downloading completion message
Press any button.
⁄
•
Up to 1000 phone numbers can be registered for each
registered cell-phone.
•
Up to 32 digits can be registered for each phone number
along with up to 50* characters representing a name.
(* 50: Number of alphabetic alphabetical characters.
Fewer characters can be input depending on the type of
characters.)
•
To cancel downloading of the phone book data, operate
the cell-phone.
46
|
KDC-BT51U/ KDC-5751SD/ KDC-5051U
Selecting the Bluetooth device you
wish to connect
When two or more Bluetooth devices have already
been registered, you need to select the Bluetooth
device you wish to use.
1
Enter Bluetooth mode
KDC-BT51U
Press the [ ] button.
KDC-5751SD KDC-5051U
Press the [LOG] button for at least 1 second.
"BT MODE" is displayed.
2
Enter Function setting mode
Press the Control knob for at least 1 second.
3
Select Bluetooth device selection mode
The item can be selected and determined as
follows.
"Settings" > "Pairing"
select the cell-phone) or "Audio Selection" (to
select the audio player)
To select the item, turn the Control knob. To
determine the item, press the Control knob.
"(name)" is displayed.
4
Select a desired Bluetooth device
Turn the Control knob to select Bluetooth
device name, and then press the Control knob.
'✱(name)' or '-(name)' is displayed.
"✱": The selected Bluetooth device is busy.
"-": The selected Bluetooth device is on standby.
" " (blank): The Bluetooth device is deselected.
5
Exit Bluetooth mode
Press the [SRC] button.
⁄
•
If a cell-phone is already selected, deselect it, and then
select a different one.
•
If you cannot select a device using the audio player,
connect the device with the audio player.
> "Phone Selection" (to