Table of Contents
Advertisement
Set ID Setup
This feature allows you to set an ID for the product.
Installation Menu (V 3.0)
LG Digital Signage Setup
USB Cloning
Password Change
Set ID Setup
Set ID Setup
Configuration Setup
Lock Mode
External Speaker / Audio out
Fail Over
ISM Method
Easy Brightness Control
S/W : xx.xx.xx.xx Micom : x.xx.x
Set ID Lock
•
You can enable Set ID Lock by selecting "Yes" or cancel Set ID Lock by selecting "No" .
Set ID
•
Pick and enter a number between 1 - 255 (1 - 1000, with some models) for the Set ID.
Auto Set ID
•
This feature sets an ID for the product automatically.
Setting ID Automatically.
Do you want to start with 1?
(Current Set ID : 1)
Yes
•
If you set this feature to Yes, all monitor in the RS-232C daisy-chain are assigned a sequential Set ID, starting with 1.
•
If you set this feature to No, Set IDs are assigned to the monitor sequentially, starting with the foremost set.
•
A Set ID cannot be decreased from its current value. Therefore, it is recommended that you execute Reset ID before
using this feature.
•
Execution time may vary depending on the installation environment.
•
If the Auto Set ID operation is not completed normally, turn the product off and on, and then try again.
•
The Yes/No options only work on the foremost monitor in the daisy-chain.
(This feature may not be available with some models.)
OK
No
Set ID Setup
Set ID Lock
Set ID
Auto Set ID
Reset ID
Previous
19
No
1
Press OK
Press OK
OK
Advertisement
Table of Contents
