Changing The Dynadock Utility Settings - Toshiba PA3575U-1PRP dynadock U User Manual

dynadock™
4. After the dynadock is removed from the system successfully, the
system will go into sleep mode.
CAUTION: It is important that you correctly disconnect the dynadock by
following the steps above. Failure to do so may cause data loss and/or
damage to your computer and devices connected through the dynadock.

Changing the dynadock Utility Settings

The TOSHIBA dynadock Utility setting program allows users to change the
"Eject Dock" setting.
Opening the Setting Dialog box
1. Click "Start" and then click "Control Panel".
2. Double-click the "TOSHIBA dynadock Utility" icon.
Note: If you can not find the "TOSHIBA dynadock Utility" icon, please click
"classic view" on the left of the control panel window.
3. Setting dialog will appear.
Setting charge mode
This will allow users to set the charge mode after the dynadock is
disconnected from computer or the computer's power is turned off.
Check the "Set charge mode after undock" box to enable the USB
n
charge function when the dynadock is disconnected from the computer
or the computer's power is off. When the charge function is active, the
Status LED will glow orange. You can press the undock button to switch
between charge and non-charge.
EN-38
(Sample Image) charge mode screen
User's Manual