Adjusting Video Settings - Toshiba PA3575U-1PRP dynadock U User Manual

dynadock™

Adjusting Video Settings

There are three components that make up the screen mode:
Resolution: In common usage, this refers to the number of pixels
displayed on the screen horizontally and vertically.
Color Depth: This defines the number of different colors that can be shown
on the screen at the same time.
Refresh rate: Measures the speed that the entire screen is rescanned.
Higher frequencies reduce flicker.
Below is a list of refresh rates supported at various resolutions and color
depths for the VGA and DVI component:
Color
Depth
16 bit
32 bit
16 bit
32 bit
Note that interlaced modes are not supported and the resolutions listed
above may not be supported by your monitor.
Additional modes may be offered, depending upon the connected monitor,
but these are not currently guaranteed.
If the monitor does not advertise the supported modes, the VGA or DVI
component will choose a set of common screen modes.
If cloning the primary display, the VGA or DVI component will try to use the
preferred monitor mode. In some cases, this may not be the most
appropriate mode for the mirrored desktop. It is recommended that the
primary display resolution be changed to closer match the default
resolution of the dynadock monitor.
NOTE: For more information on supported modes, be sure to check the
documentation supplied with your monitor.
EN-32
640x480 800x600
60 72 75 56 60 72
75 85
60 72 75 56 60 72
75 85
1280x800 1440x900
60 60
60 60
Resolution
1024x768 1280x768
60 70 75 60 75 85
85
60 70 75 60 75 85
85
1600x1200 1680x1050 1920X1200
60 60
60 60
1280x960 1280x1024
60 85 60 75 85
60 85 60 75
60
60
User's Manual