Advertisement
INSTALLATION AND TECHNICAL SPECIFICATIONS
Installation
1. Connect the speaker wire to the speaker terminals:
Leave about 2' (60 cm) of wire extending through the ceiling or wall
•
cutout.
Pull the conductors apart so the last two inches are separated and
•
remove 1/2" (13 mm) of insulation from the end of each conductor.
Twist the strands in each conductor into tight spirals.
•
Attach the speaker wires to the red and black speaker terminals.
•
Connect the Positive (+) conductor to the Red terminal and the
Negative (-) conductor to the Black terminal. Make sure that no stray
strands of wire are touching the other conductor or terminal.
(+)
(-)
(+)
(-)
Insertion of speaker wire on back of speaker baffle
Center the speaker in the cut out. The patented* SwiftLock by Swarm design.
For the IW-620, position the speaker in the opening and hold it in place,
then press each of the four SwiftLock installation buttons. You will hear a
resounding "click" letting you know the speaker is securely mounted in place.
3. Attach the magnetic grille.
Speaker
Install Speaker
Press each of the four
SwiftLock installation
buttons. (One for each
of the four dogs).
*US Patent 10,024,493
Removing a SwiftLock Speaker
Removing a SwiftLock speaker is quick and easy. Simply
insert a #2 Phillips Screwdriver into the screwhead, push
the screw in and turn the screw a 1/2-turn counter-
clockwise to lock it into place.
Repeat for the other SwiftLock mounting dogs
4
Russound Architectural Series of In-Wall Loudspeakers
Listening Test
It's a good idea to test everything at this point.
1.
2.
3.
4.
5.
Speaker Cable
Cutout
Type
Tweeter
Woofer
Cutout Dimensions in (cm)
Frequency Response
Impedance (Ω)
Magnet Structure oz (Kg)
Mounting Depth in (cm)
Overall Dimensions Ø in (cm)
Recommended Power
Sensitivity @1W/1M
Grille Color
Turn on your stereo system or music source. Make sure that the
volume control is turned down and that the balance control is set
to center.
Gently turn up the volume. You should hear music coming out of your
new Russound Speakers! (If you don't, refer to the troubleshooting
guide.)
Now rotate the stereo's balance control all the way to the left. Sound
should only come out of your left speaker. If it comes out of the right
speaker, skip to Step 5.
Rotate the balance control all the way to the right. Sound should only
come out of the right speaker.
If sound comes from the right speaker when the stereo's balance
control is turned to the left, you'll need to change the connections
on the back of the amplifier/receiver. Note: Turn off the amplifier.
Swap the wires attached to the left and right speaker terminals before
turning the amplifier back on. Make sure to keep the (+) and (-) the
same for left and right speakers.
Two-way In-wall
1"/(25mm) Pivoting Titanium
6.5''(16.51 cm)IM Polypropylene with
vapor deposited Titanium Cone
H-11.75(29.85) W=7.64(19.4)
42Hz-25Khz
8
13 (0.383)
3.63 (9.21)
H=12.81(32.54)xW=8.71(22.13)
5-110 watts RMS
90 dB
Bright White
Advertisement
