Adding Multi-Tablets; Setting And Starting A Programme - Zanussi ZDT22003FA User Manual

ADDING MULTI-TABLETS

• Do not fill the salt container and the rinse aid dispenser.
• Set the rinse aid dispenser to the lowest position.

SETTING AND STARTING A PROGRAMME

Starting a programme
1. Keep the appliance door ajar.
2. Press the on/off button to activate the appliance. Make sure that the appliance is in programme
selection mode.
3. Press the programme button until the indicator of the chosen programme is flashing.
4. Close the appliance door to start the programme.
Option delay
1. Set the programme.
2. Press the Delay button to postpone the start of the programme by 3 hours. The Delay indicator is on.
3. Close the appliance door to start the countdown.
When the countdown is completed, the programme starts.
Opening the door while the appliance
operates
Opening the door while a programme is running
stops the appliance. It may affect the energy
consumption and the programme duration. After
closing the door, the appliance continues from the
point of interruption.
If the door is opened for more than 30
seconds during the drying phase, the
running programme ends. It does not
happen if the door is opened by AirDry
function.
End of the programme
When the programme is completed the indicator
1. Press the on/off button or open the door to deactivate the appliance.
2. Close the water tap.
After 5 minutes of non-use, the appliance enters standby mode and all the indicators are off. It
decreases the energy consumption.
10
1
2
is on.
Do not try to close the appliance door
within 2 minutes after AirDry
automatically opens it, as this may
cause damage to the appliance.
If, afterwards, the door is closed for
another 3 minutes, the running
programme ends.