Table of Contents
Advertisement
Problem
Not dispensing
New installation or water line
water.
recently connected.
The dispenser panel is locked.
The dispenser is not set for water
dispensing.
Refrigerator or freezer doors are not
closed properly.
Water filter has been recently
removed or replaced.
Tubing connecting refrigerator to
house supply valve is kinked.
The house water supply is not
connected, the valve is not turned
on fully, or the valve is clogged.
38
Possible Causes
Care and maintenance
Solutions
Dispense 10 litres of water (flush for
approximately 5 minutes) to remove
trapped air and contaminates from the
system. Do not dispense the entire 10
litres amount continuously. Depress and
release the dispenser pad for cycles of 30
seconds ON and 60 seconds OFF.
Press and hold the Lock button for three
seconds to unlock the control panel and
dispenser.
The dispenser can be set for ice or water.
Make certain that the control panel is set
for the proper operation. Press the Water
button on the control panel to dispense
water.
Water will not dispense if any of the
refrigerator doors are left open.
After the water filter is replaced, dispense
10 litres of water (flush for approximately
5 minutes) to remove trapped air and
contaminates from the system. Do not
dispense the entire 10 litres amount
continuously. Depress and release the
dispenser pad for cycles of 30 seconds
ON and 60 seconds OFF.
The tubing can kink when the refrigerator
is moved during installation or cleaning
resulting in reduced water flow. Straighten
or repair the water supply line and arrange
it to prevent future kinks.
Connect refrigerator to the water supply
and turn the water shutoff valve fully
open.
If the problem persists, it may be
necessary to contact a plumber.
Advertisement
Table of Contents
