Table of Contents
Advertisement
Insert the dump handle through the slot in the trailer pan
and through the handle spring P#(J0310) as shown in
Figure B.
Figure B
Dump Handle
Handle
Spring
Note: The Dump Handle contains 2 holes that are
specific to the type of Trailer Vac it is being installed on.
The First hole is for the X30 Trailer Vac and the Second
hole is for the X20 Trailer Vac.
Insert the pivot bolt through the hole corresponding with
your Trailer Vac in the dump handle. Secure the handle
to the pivot bolt using the 3/8"-16 Nut that was removed.
Attach the hook end of the spring to the hole in the trailer
pan. Refer to Figure C.
Figure C
3/8"-16 Nut
Insert the Handle Grip P#(J0522) onto the end of the
dump handle as shown in Figure D.
Figure D
Wheel Installation
Remove the tape from both axles. Refer to Figure A and
Figure B for reference.
Attach Spring To
Trailer Pan
Insert the wheels onto the wheel axle as shown in Figure
C. Secure each wheel using (1) 3/4" flat washer
P#(K0061) and (1) 1/8"-1/2" cotter pin P#(K0085). Refer
to Figure C below and Figure D on the next page.
Handle Grip
Figure A
Remove Tape
From Axle
Figure B
Tape Removed
From Axle
Figure C
Insert Wheel
Onto Axle
9
Advertisement
Table of Contents
