Table of Contents
Advertisement
LW20 / SF20 LiDAR sensor
Product manual
Once the correct setting is applied, commands can be sent and results viewed by selecting the "I2C Tester" icon and pressing the one
of the test buttons available in the dialog box.
Figure 16 :: I2C test dialog box showing command buttons
The factory default I2C bus address is 0x66.
|
|
|
LW20 / SF20 LiDAR - Product manual - Revision 7
14
of
28
© LightWare Optoelectronics (Pty) Ltd, 2018
www.lightware.co.za
Advertisement
Table of Contents
