Table of Contents
Advertisement
TX90 6kVA & 10kVA User's Manual
P
UPS inner temperature
Viewing the UPS Default Settings
• After the UPS completely starts up, press the
Q1
Buzzer "On". Use the
Q2
Buzzer "Off"
• Press the
key to scroll through the UPS settings. The LCD will display in sequence figure Q1 (buzzer) →
figure R (Self-test) → figure S (Bypass Voltage Windows) → figure T (Output Frequency Synchronization
Window) → figure U (Inverter Output Voltage) → figure V (UPS Operation Mode) → figure W (Output Volt-
age Micro Tune Value) → figure X (UPS Id) → figure Y (Parallel function status).
• Buzzer and Self-test can only be changed in this mode while the UPS is on. All other settings must be
changed while the inverter is off in this mode. See Changing the UPS Default Settings on page 22.
• Default settings shown below.
R
Self-test is not "On". Use the
Xtreme Power Conversion Corporation
(function) key to change the LCD display to figure Q1.
key to toggle the setting and then save.
key to toggle the setting and then save.
Uninterruptible Power Supply
Page 19
Advertisement
Table of Contents
