Installation: Location: Electrical - Gastrodomus RC 300 Series Instruction Manual

Installation: Location: Electrical

The cabinet is intended for connection to an alternating current. The connection voltage (V) and frequency (Hz) are
shown on the name plate in the cabinet. The power connection is made using a three-pin plug to a wall socket. Any
requirement for earthing from the local power supply must be met. The cabinet plug and wall socket should then give a
correct earthing. If you are in doubt, contact your local supplier or authorized electrician.
The colours of the wires in the mains lead of this appliance might not correspond with the coloured markings identifying
the terminals in your plug. Proceed as follows:
The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked"E", marked
by the earth symbol or coloured green-and-yellow. The wire, which is coloured blue, must be connected to the terminal,
which is marked with the letter "N", or coloured black. the wire which is coloured brown must be connected to the terminal
which is marked with the letter"L" or coloured red.
Warning - This appliance must be earthed
The flexible cord fitted to this appliance has three cores for use with a 3-pin 13 Amp plug.
If a B.S. 1363 (13 Amp) fused plug is used, it should be fitted with a 13 Amp fuse or a
moulded right-angled Schuko plug. Note the plate with a hole in it between and above the
two pins - this connects to French and Belgian sockets, which have an earth pin that sticks
out. Running in a slot coming from that plate is a continuation strip from the plate. Other
European countries use a socket with a scrolled metal connector emerging from the side
which mates with that strip. This ensures that the Schuko can be used in most mainland
European countries.
Important
The wires in this mains lead are coloured in accordance with the following code:
Green-and-yellow: earth
Blue: neutral
Brown: live
5
ORIGINAL INSTRUCTION
GB