M-system R7L-RS4 Instruction Manual page 17

■ FUNCTIONAL BLOCK: fbDOEX[0...7]
• Network Properties
TYPE
NETWORK
{ Range }
VARIABLE
{ Default }
{SNVT_switch}
nviDOEX1 {0.0 0}, {100.0 1}, {Invalid}
{0.0 0}
{SNVT_switch}
nviDOEX2 {0.0 0}, {100.0 1}, {Invalid}
{0.0 0}
• Configuration Properties
CONFIGURATION NETWORK
PROPERTY VARIABLE
SCPTdirection ----
SCPTpwrUpState nviDOEX1
SCPTpwrUpState nviDOEX2
EXPLANATIONS
Turns on or off Y0, Y2, Y4, Y6, Y8, YA, YC, YE of the extension module
depending upon this input.
100.0 1 : ON
Other : OFF
Turns on or off Y1, Y3, Y5, Y7, Y9, YB, YD, YF of the extension module
depending upon this input.
100.0 1 : ON
Other : OFF
TYPE
{ Range }
{ Default }
{SNVT_state}
{0 or 1}
{0,0,0,0,0,0,0,0,
0,0,0,0,0,0,0,0}
{SNVT_switch}
{0.0 0}, {100.0 1},
{Invalid}
{0.0 0}
{SNVT_switch}
{0.0 0}, {100.0 1},
{Invalid}
{0.0 0}
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
EXPLANATIONS
Bit 1: Output held or not at power off
0 : OFF at the power startup
1 : Outputs the held status at the power startup
Bit 0, Bit 2 through 15 : Invalid
Set value applied at nviDOEX1 when the power supply is
turned on.
Set value applied at nviDOEX2 when the power supply is
turned on.
R7L-RS4
EM-7804-C Rev.5 P. 17 / 19