Elo Touch Solutions E607608 User Manual page 32

Touchmonitors

Notice to Users in Canada:

This equipment complies with the Class B limits for radio noise emissions from digital

apparatus as established by the Radio Interference Regulations of Industrial Canada.

CAN ICES3(B)/NMB3(B)

This device complies with Industry Canada's license-exempt RSSs. Operation is subject to the

following two conditions:

(1) This device may not cause interference; and

(2) This device must accept any interference, including interference that may cause undesired

operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio

exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :

(1) l'appareil ne doit pas produire de brouillage;et

(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le

brouillage est susceptible d'en compromettre le fonctionnement.

Notice to Users in the European Union: Use only the provided power cords and interconnecting

cabling provided with the equipment. Substitution of provided cords and cabling may compromise

electrical safety or CE Mark Certification for emissions or immunity as required by the following

standards:

This Information Technology Equipment (ITE) is required to have a CE Mark on the Manufacturer's

label which means that the equipment has been tested to the following Directives and Standards:

This equipment has been tested to the requirements for the CE Mark as required by EMC Directive

2014/30/EU as indicated in European Standard EN 55032 Class B and the Low Voltage Directive

2014/35/EU as indicated in European Standard EN 60950-1.

General Information to all Users: This equipment generates, uses and can radiate radio frequency

energy. If not installed and used according to this manual the equipment may cause interference with

radio and television communications. There is, however, no guarantee that interference will not occur

in any particular installation due to site-specific factors.

1) In order to meet emission and immunity requirements, the user must observe the following:

a) Use only the provided I/O cables to connect this digital device with any computer.

b) To ensure compliance, use only the provided manufacturer's approved line cord.

Table of Contents

1915l E266835