Table of Contents
Advertisement
NOTE: The range cooktop is equipped with 4 burners: 1 burner
is power (left front), 2 burners are standard (right front and left
rear), and 1 burner is simmer (right rear).
A. Standard burner - Natural gas orifice spud number 149
B. Power burner - Natural gas orifice spud number 165
C. Simmer burner - Natural gas orifice spud number 110
D. Standard burner - Natural gas orifice spud number 149
5. Place LP gas orifice spuds in the parts bag for future use
and keep with the bag containing literature.
6. Reinstall burners, burner caps and burner grates.
To Convert Oven Burner
1. Open the oven door and remove oven racks and oven tray
with flame spreader, and set aside.
2. Remove screw from the oven burner. Lift oven burner and
pull the burner toward you. The orifice spud is behind the
oven burner air shutter.
B
A. Oven burner
B. Air shutter
C. Screw
W10860789A
3. Locate Natural gas orifice spud stamped "47" in the bag
4. Use a ³⁄
5. Install the number "47" Natural gas spud.
6. Place LP gas oven burner spud in plastic parts bag along
7. Reinstall oven burner.
8. Reinstall oven racks, oven tray, and flame spreader.
1. Refer to the "Make Gas Connection" section for properly
2. Turn the manual shut-off valve in the gas supply line to the
3. Refer to the "Electronic Ignition System" section for proper
A
C
4. Close the broiler door and press the Cancel/Off pad.
5. Refer to the "Complete Installation" section to complete
© 2016. All rights reserved.
containing literature supplied with the range.
" combination wrench and remove the LP gas
8
orifice spud.
A
A. Natural gas oven orifice spud stamped with "47"
IMPORTANT: Do not overtighten.
with LP gas cooktop burner spuds for future use and keep
with the bag containing literature.
Complete Conversion
connecting the range to the gas supply.
open position.
burner ingestion, operation, and burner flame adjustments.
IMPORTANT: You may have to adjust the LO setting for each
cooktop burner.
Checking for proper cooktop and oven burner flames is very
important. The small inner cone should have a very distinct
blue flame ¼" to ½" (0.64 cm to 1.3 cm) long. The outer cone
is not as distinct as the inner cone. Natural gas flames do not
have yellow tips.
this procedure.
1/16
Advertisement
Table of Contents
