Startup - Hoshizaki DCM-500B H Instruction Manual

H. Startup
• All parts are factory-adjusted. Improper adjustments may adversely affect safety,
performance, component life, and warranty coverage.
• If the icemaker is turned off, wait for at least 3 minutes before restarting the
icemaker to prevent damage to the compressor.
• At startup, confirm that all internal and external connections are free of leaks.
1) Open the water supply line shut-off valve(s).
2) Move the control switch to the "OFF" position. See Fig. 7.
3) Remove the front panel, then move the power switch to the "ON" position. Replace the
front panel in its correct position, then turn on the power supply.
Note: This unit will not run if the safety switch is not engaged.
4) Move the control switch to the "ICE" position to start the automatic icemaking process.
5) Once the unit starts to produce ice, allow it to run for another 30 minutes.
6) Move the control switch to the "OFF" position, pause momentarily, then move to the
"DRAIN" position. Allow the water system to drain for 5 minutes.
Note: a) A momentary pause in the "OFF" position is necessary to de-energize the
control board when moving the control switch between "ICE" and "DRAIN."
Otherwise there is a delay of several minutes before the new selection takes
effect.
b) If the control switch is left in the "DRAIN" position for 10 minutes or more, a
2-beep alarm sounds every 5 seconds. Move the control switch out of the
"DRAIN" position to clear the alarm.
7) Move the dispense mode switch to the "CONTINUOUS" position, then dispense all of
the ice from the ice storage bin.
Note: Ice dispenses continuously for a maximum of 60 seconds per activation.
8) Remove the front panel, then remove the ice storage bin cover.
9) Move the control switch to the "ICE" position.
WARNING
Ice Storage
Bin Cover
Power Switch
Control Box Cover
Safety Switch
4A1038-014
CONTROL
ICE
DISPENSE MODE
OFF
PORTION
DRAIN
CONTINUOUS
Fig. 7
21
Actuator Paddle