Installation Of Upper Unit - Hoshizaki KM-1301SWH/3 Instruction Manual

If a Hoshizaki B-1300, B-1500, B-1650, or non-Hoshizaki ice storage bin is used:
g. Remove the 2 screws securing the thermostat bulb attachment (plastic) to the
thermostat extension bracket (stainless). Use the 2 screws to attach the "Z" bracket
(plastic) to the thermostat extension bracket (stainless).
h. Use the two 4×10 stainless steel screws in the accessory bag to attach the
thermostat bulb attachment (with attached thermostat bulb) to the "Z" bracket.
i. Remove the 2 screws from the lower part of the thermostat bracket (plastic) and use
them to attach the thermostat extension bracket (stainless) to the thermostat bracket
(plastic). See Fig. 9.
7) Replace the panels and baffle in their correct positions unless you are installing
an upper unit. If you are installing an upper unit, see "II.D.3. Installation of Upper Unit."
Note: The bin control thermostat must be checked for proper operation at startup.

3. Installation of Upper Unit

1) See "II.D.1. Dispenser Unit/Ice Storage
Bin and Icemaker Setup" and "II.D.2. Bin
Control Installation" for the lower unit
installation.
2) Remove the top panel and the top
insulation of the lower unit. These pieces
must be removed when installing an upper
unit.
3) Unpack the upper unit, and remove
the shipping carton, tape, and packing
material.
4) Remove the panels of the upper unit.
5) Stack the upper unit on top of the lower
unit.
6) Secure the upper unit to the lower unit
using the 2 mounting brackets and the
bolts provided. See Fig. 10.
7) Remove the tie securing the upper unit's
bin control thermostat assembly.
Thermostat Bracket
(plastic)
Thermostat Bulb
Attachment (plastic)
Thermostat Extension
Bracket (stainless)
"Z" Bracket (plastic)
Fig. 9
Icemaker
(Upper Unit)
Ice
Storage
Bin
22
Mounting
Brackets
Bolts
Icemaker
(Lower Unit)
Fig. 10