B) Km-1900/2100/2500S_H/3 - Hoshizaki KM-1301SWH/3 Instruction Manual

b) KM-1900/2100/2500S_H/3

6) Install the bin control thermostat as follows:
a. Remove the baffle from the ice storage bin.
b. Remove the tie securing the bin control thermostat assembly. Remove the
2 thumbscrews and the "Z" bracket.
c. Remove the bin control thermostat assembly from the shipping hook by lifting it up
and shifting it to the right. Lower the thermostat extension bracket (stainless) with
the thermostat bulb attachment and thermostat bulb through the hole located at the
bottom of the icemaker. Next, lower the thermostat bracket (plastic) through the hole.
See Fig. 6.
d. Slide the left side of the upper part of the assembly towards you and make sure it
is hooked on the wall. Make sure the left side and bottom of the assembly are flush
against the wall and base panel.
e. Secure the assembly into place with the thumbscrews unless you are installing
an upper unit. If you are installing an upper unit, complete steps f through h or
f through i (depending on the ice storage bin used) and then see "II.D.3. Installation
of Upper Unit."
f. Insert the plug into the receptacle on the assembly until it locks into place. See Fig. 7.
Wall
Shipping Hook
Thermostat Bracket
(plastic)
Tie
Thermostat Bulb
Attachment (plastic)
and Thermostat Bulb
If a Hoshizaki B-800, B-900, or B-1150 ice storage bin is used:
g. Put aside the "Z" bracket; it is not needed
with the ice storage bins listed above.
h. Remove the 2 screws from the lower part
of the thermostat bracket (plastic) and use
them to attach the thermostat extension
bracket (stainless) to the thermostat
bracket (plastic). See Fig. 8.
Bin Control Thermostat Assembly
Thermostat Extension
Bracket (stainless)
"Z" Bracket
Thumbscrews
Hole
Fig. 6
Plug
Receptacle
Fig. 7
Fig. 8
21
Hook
Thumbscrews
Thermostat Bracket
(plastic)
Thermostat Extension
Bracket (stainless)
Bushing