Badger Meter Impeller ModHopper R9120-5 User Manual page 11

135 40136 UINT16
136 40137 UINT16
137 40138 UINT16
138 40139 UINT16
139 40140 UINT16
140 40141 UINT16
141 40142 UINT16
142 40143 UINT16
143 40144 UINT16
144 40145 UINT16
145 40146 UINT16
146 40147 UINT16
147 40148 UINT16
148 40149 UINT16
149 40150 UINT16
150 40151 UINT16
151 40152 UINT16
152 40153 UINT16
153 40154 UINT16
154 40155 UINT16
155 40156 UINT16
156 40157 UINT16
157 40158 UINT16
712 40713 UINT16
June 2016
Radio Serial MSW
Radio Serial LSW
Radio Firmware
Radio Type 1=R9120-1(lowpower), 2=R9120-3(highpower) 0=unknown)
(R/W) Modbus 485 timeout in ms. Default 240ms range 40max to 2000ms.
Affects modhopper in master mode only.(max 5000ms in v1.17)
(R/W) Pulse KYZ flag bitmap. 0x01 = pulse1 kyz mode, 0x02=p2, etc.
Reserved
(R/W) RS485 force master/slave modes. 0=auto/default, 1=force-mas-
ter, 2=force-slave. (firmware 1.17 or later)
RS485 master/slave mode status. 0=master, 1=slave. (firmware
1.17 or later)
RS485 baud rate.2=9600, 3=19200.(firmware 1.17 or laer)
(R/W) contact closure threshold. in ohms. 100-2550 ohms allowed.
(rev-c only, firmware 2.02 or later)
(R/W) contact closure speed, pulse speed: 0=10Hz/default, 1=50Hz,
2=100Hz, 3=250Hz(firmware 2.02 or later)
power supply voltage monitor (rev-c only) scale: x100
pcb temperature monitor(rev-c only) scale: x100
400MHz RX Good packet count(rev-c only)
400MHz RX Bad packet count(rev-c only)
(R/W) minimum packet time, how frequent to save sensor data packets.
(10-2550 seconds)(firmware 2.02 or later)
RS485 serial port option:(firmware 2.05 or later) bits 0-1:
0=N, 1=E, 2=O
bit 2: 0=8bit, 1=7bit
bit 3: 0=1stop, 1=2stop
Note: read only, always returns 8N1
Radio RF speed mode (0=distance, 1=speed) (rev-c, -5
modhopper only, fw 2.05 or later )
Reserved
(R/W) preference lock.0=unlocked, 1=locked. when locked, preferences
can be changed from 485 port only.(firmware 2.05 or later)
AES Encryption key present.
0=not available, 1=not-active,2=key-active/256bit. (firmware
2.05 or later, -5 modhopper only)
Max allowed software RF channel setting.0=not available. (firmware
2.06 or later)
bitmap of known radios (16 registers) LSB, MSB order.
bit0=n/a, bit1=addr1, etc.
XMT-UM-02107-EN-01
Modbus Features
Page 11