Before Washing/Drying For The First Time; Transportation - Siemens WD15H547EP Instruction Manual

Before washing/drying for the
first time
The washer dryer was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
retirar pelusas/fios (Fluff Clean)
programme the first time without
laundry.
Note:
The washer dryer must have been
■
installed and connected properly.
Installation and connection
~ Page 37
Never switch on a damaged
■
machine.
Inform your customer service
~ Page 35
Insert mains plug.
1.
Turn the tap on.
2.
Switch on the appliance.
3.
Close the washing machine door.
4.
Do not load any laundry.
Select the retirar pelusas/fios (Fluff
5.
Clean) 40°C programme.
Open the detergent drawer.
6.
Pour approx. 1 litre of water into
7.
dispenser II.
Add standard detergent to
8.
dispenser II according
to manufacturer's instructions for
light soiling.
To prevent frothing, use only
Note:
half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
Close the detergent drawer.
9.
Select inicio/pausa+carga
10.
(Start/Reload) !.
When the programme ends, switch
11.
off the appliance.
Your washer dryer is now ready for
use.
Installation and connection

Transportation

Preparatory work
Turn off the tap.
1.
Release the water pressure in the
2.
supply hose.
Filter in the water inlet hose blocked
~ Page 29
Drain any residual washing water.
3.
Drain pump blocked ~ Page 29
Disconnect the washer dryer from
4.
the power supply.
Remove the hoses.
5.
Installing the transportation protection
devices:
Remove the covers and keep in
1.
a safe place.
If required, use a screwdriver.
Insert all 4 sleeves.
2.
Clamp the mains cable on the
holders. Insert and tighten the bolts.
Before switching on the appliance:
Notes
Always remove the transportation
■
protection devices!
To prevent unused detergent from
■
flowing into the outlet during the next
wash: Pour 1 litre of water into
dispenser II and start the 0 (Spin)/
p (Empty) programme.
en
43