End Of The Programme; After Washing/Drying - Siemens WD15H547EP Instruction Manual

End of the programme

– 0 – or – – – – is indicated in the
display and acoustic signal sounds.
Setting the signal ~ Page 27
If – – – (Rinse stop = without final drain/
spin cycle) was selected, press the
inicio/pausa+carga (Start/Reload) !
button to start final drain/spin cycle.
Notes
The programme continues by
■
pumping out the water and spinning
the laundry (the standard spin speed
can be changed beforehand).
If only the water is to be pumped out,
■
approx. 1 minute after the
programme starts, touch the inicio/
pausa+carga (Start/Reload) !
button before the spin cycle starts,
then turn the programme selector to
$ (Off). The programme is
interrupted and the door lock is
released. The laundry can be
removed.
If the drying function is actuated,
■
PUSH, to, End alternates on the
display, the inicio/pausa+carga
(Start/Reload) ! indicator light
flashes and an acoustic signal
sounds.
Drum continues running for 30 min
■
in special pace to prevent laundry
from creasing.
If you want to remove the laundry
■
immediately, touch any button to
cancel or reselect a programme.
If hot flashes in the display before
■
the drying programme ends, the
temperature in the drum is high. The
programme for cooling the drum
runs until the temperature in the
drum has dropped.
Operating the appliance

After washing/drying

Open the door and remove the
1.
laundry.
Turn the programme selector to
2.
$ (Off). The appliance is switched
off.
Turn off the tap.
3.
Not required for Aqua-Stop models.
~ Page 37
Disconnect the mains plug.
4.
Notes
Do not leave any items of laundry in
■
the drum. In the next wash they may
shrink or discolour another item.
Remove any foreign objects from
■
the drum and the rubber seal – risk
of rust.
Leave the detergent drawer and
■
door open so that residual water can
evaporate.
Always remove the laundry.
■
Always wait until the programme
■
ends, as the appliance could still be
locked. Then switch the appliance
on and wait for the unlocking device.
When the display panel has gone
■
out at the end of the programme,
energy-saving mode is active. To
activate, select any button.
en
19