Before washing/drying for the
first time
The washer dryer was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Fluff/Drum Clean 40°C programme the
first time without laundry.
Note:
The washer dryer must have been
■
installed and connected properly.
Installation and connection
~ Page 37
Never switch on a damaged
■
machine. Inform your customer
service. ~ Page 35
Insert mains plug.
1.
Turn the tap on.
2.
Switch on the appliance.
3.
Close the washer dryer door. Do not
4.
load any laundry.
Select the Fluff/Drum Clean 90°C
5.
programme. For AU variant, two
cycle of Fluff/Drum Clean 90°C
programme without laundry are
required to be run at initial setup,
and this operation only needs to be
completed once.
Open the detergent drawer.
6.
Pour approx. 1 litre of water into
7.
dispenser II.
Add standard detergent to
8.
dispenser II according
to manufacturer's instructions for
light soiling.
Note:
To prevent frothing, use only half the
recommended amount of detergent.
Do not use detergent for wool or
delicates.
Close the detergent drawer.
9.
Select Start/Reload.
10.
When the programme ends, switch
11.
off the appliance.
Your washer dryer is now ready for
use.
Installation and connection
Transportation
Preparatory work
Turn off the tap.
1.
Release the water pressure in the
2.
supply hose.
Filter in the water inlet hose blocked
~ Page 30
Drain any residual washing water.
3.
Drain pump blocked ~ Page 29
Disconnect the washer dryer from
4.
the power supply.
Remove the hoses.
5.
Installing transportation protection
devices:
Remove the covers and keep in a
1.
safe place.
If required, use a screwdriver.
Insert all 4 sleeves.
2.
Clamp the mains cable on the
holders. Insert and tighten the bolts.
Before switching on the appliance:
Notes
Always remove the transportation
■
protection devices!
To prevent unused detergent from
■
flowing into the outlet during the next
wash: Pour 1 litre of water into
dispenser II and start the Spin or
Drain programme.
en
43