Selecting Installation Location; Installation Guide At The Seashore - Samsung AG010KSV Series Installation Manual

Selecting installation location

Decide the installation location, with the consideration
of the following conditions, under user's approval.
Place where hot discharge air or noise from the DVM
CHILLER may not disturb the neighbor (Especially in
residential areas, keep the operation hours in mind.)
Place where structure can bear the weight and
vibration of the DVM CHILLER
Place with flat surface where rainwater does not
settle or leak
Place where it is not exposed to strong wind
Well ventilated place with sufficient service place
for repairs and maintenance (Discharge duct can be
purchased separately)
Place where it allows easy waterproofing and
draining work for the condensation water generated
from the DVM CHILLER during heating operation
Place where there is no risk of inflammable gas leakage
Place where there is no direct influence of snow or rain
Place where a large amount of water generated by
external environment does not directly affect the top
of the outdoor unit.

Installation Guide at the seashore

Make sure to follow below guides when installing at
the seashore.
Do not install the product in a place where it is
directly exposed to sea water and sea breeze.
- Make sure to install the product behind a structure
(such as building) that can block see breeze.
- Even when it is inevitable to install the product
in seashore, make sure that product is not
directly exposed to sea breeze by installing a
protection wall.
Consider that the salinity particles clinging to the
external panels should be sufficiently washed out.
Because the residual water at the bottom of the
outdoor unit significantly promotes corrosion,
make sure that the slope does not disturb drainage.
- Keep the floor level so that rain does not
accumulate.
- Be careful not to block the drain hole due to
foreign substance
12
English
When product is installed in seashore, periodically
clean it with water to remove attached salinity.
Make sure to install the product in a place that
provides smooth water drainage. Especially, ensure
that the base part has good drainage.
If the product is damaged during the installation or
maintenance, make sure to repair it.
Check the condition of the product periodically.
- Check the installation site every 3 months and
perform anti-corrosion treatment such as R-Pro
supplied by SAMSUNG (Code : MOK-220SA) or
commercial water repellent grease and wax, etc.,
based on the product condition.
- When the product is to be shut down for a long
period of time, such as off-peak hours, take
appropriate measures like covering the product.
If the product installed within 500 m (1640.4 ft) of
seashore, special anti-corrosion treatment is required.
Please contact your local SAMSUNG
representative for further details.
Sea breeze
Sea
Sea breeze
Sea
DVM
CHILLER
DVM
CHILLER
DVM
CHILLER